All ArticlesCommercial

Panic Bar Installation for Commercial Doors in Dallas

Updated September 23, 2026 5 min read

What Is a Panic Bar?

A panic bar (also called a crash bar or exit device) is a horizontal bar across a door that, when pushed, unlocks and opens the door. They're required on commercial exit doors to allow fast, easy egress in an emergency — people can simply push the bar and exit without needing to turn a handle or use a key.

Does Your Dallas Business Need Panic Bars?

Panic bars are required by fire code and building code on certain commercial doors. In Dallas (as in the rest of the US), the International Building Code (IBC) and National Fire Protection Association (NFPA) codes require panic hardware on:

  • Assembly occupancies with 100+ people (restaurants, theaters, event spaces)
  • Educational occupancies with 100+ people (schools, daycares)
  • Daycare occupancies (regardless of occupant load)
  • High-hazard occupancies (regardless of occupant load)
  • Any door that is part of a required exit route

If you're not sure whether your doors require panic bars, a commercial locksmith or fire marshal can help you determine compliance.

Types of Exit Devices

Rim Cylinder Exit Device

The simplest type. The latch sits on the surface of the door and locks into a surface-mounted strike on the frame. The push bar retracts the latch.

Best for: Single doors, narrow stile doors

Mortise Exit Device

The lock body is mortised (recessed) into the door. The latch is a mortise lock that goes into a strike pocket in the frame. Stronger and more durable than rim devices.

Best for: High-traffic doors, heavy doors, double doors

Vertical Rod Exit Device

Instead of a horizontal latch, this device has rods that go up and down from the push bar to the top and bottom of the door. When the bar is pushed, the rods retract from the top and bottom strikes.

Best for: Double doors, wide doors, doors without a center mullion

Concealed Vertical Rod

Same as vertical rod, but the rods are concealed inside the door rather than surface-mounted. More aesthetically pleasing but harder to service.

Best for: Doors where appearance matters, narrow stile doors

Features to Consider

Dogging

"Dogging" holds the push bar in the depressed position, keeping the latch retracted so the door can be used as a push/pull door without pressing the bar. This is common during business hours.

Alarm

Many panic bars have built-in alarms that sound when the bar is pushed — deterring unauthorized exits and alerting staff. Some have a delay feature (15 seconds) to allow authorized users to exit without an alarm.

Electrified Exit Devices

For doors with access control, electrified exit devices integrate with card readers and electric strikes. The push bar always allows exit (fire code requirement), but entry is controlled by the access system.

Weather Resistance

For exterior doors, choose a device rated for outdoor use. DFW's heat and humidity can damage non-rated devices.

Fire-Rated Doors

If your door is fire-rated (part of a fire wall), the panic bar must also be fire-rated. Fire-rated exit devices are specifically designed and tested to function during a fire. They cannot have dogging features (the door must always latch to maintain the fire barrier).

ADA Compliance

Panic bars must comply with the Americans with Disabilities Act (ADA):

  • Push bar height — 34–48 inches from the floor
  • Operating force — no more than 15 pounds of force to unlatch
  • No special knowledge — anyone should be able to operate it without instructions

Professional Installation Matters

Panic bar installation is more complex than installing a residential deadbolt:

  • Correct height — must meet ADA and fire code requirements
  • Proper alignment — the latch must engage the strike correctly or the door won't secure
  • Fire code compliance — fire-rated doors need fire-rated hardware, installed per the listing
  • Door prep — may require drilling, routing, or mortising the door
  • Testing — the device must be tested to ensure it operates smoothly and latches securely

Improper installation can result in:

  • Fire code violations — fines and forced closure
  • Safety hazards — the door doesn't open in an emergency
  • Security gaps — the door doesn't latch properly, allowing unauthorized entry

Maintenance

Panic bars need regular maintenance to ensure they work when needed:

  • Test monthly — push the bar and verify the door opens and latches
  • Lubricate — per manufacturer recommendations
  • Check alignment — verify the latch engages the strike
  • Check the alarm — if equipped, test the alarm
  • Replace worn parts — don't wait for failure

See our commercial door maintenance guide for more.

Call DFW Key Master

For panic bar installation, repair, and maintenance in Dallas and the surrounding DFW area, call (682) 666-2966. We install all major brands (Von Duprin, Sargent, Corbin Russwin, Precision) and ensure code compliance — 24/7. See also our commercial locksmith services guide.

Need a Locksmith Right Now?

DFW Key Master is available 24/7 throughout Dallas-Fort Worth. Call for a firm, upfront quote.